Dell 3100 Especificações descarregar pdf (Página 100)

Stage System

Stage Menu Commands

80 Dimension 3100 Manual Rev. D

Teaching a Programmed Move

To program (teach) a series of moves, complete the following:

1. Draw a simple map of the sample, along with each programmed position, before

programmed moves are entered. Note the origin point at the time of programming.

Note: If reducing cycle time is important, position order should be optimized to

reduce stage travel

2. Click on the Program name option in the Programmed Move panel (see Figure 5.2j) and

enter the name to be used.

Note: Program names must be eight characters or less and follow DOS protocol.

3. From the Programmed Move panel, click on Teach. The screen prompts with (see Figure

5.2k):

Figure 5.2k Editing or Creating New Program Prompts

4. Click OK to proceed with programming moves. A new panel displays, featuring the basic

teaching commands (see Figure 5.2l).

5. To add a first step, click Add Step to invoke the Teach Mode panel (see Figure 5.2l).

Figure 5.2l Teach Program Prompt

6. Use the controls to position the stage and sample to the desired location(s) to be programmed

into the computer.

Note: These controls are identical to the Focus Surface controls explained in Chapter

5 of this manual.

Programmed Move

Editing existing program

Programmed Move

Creating new program

The program name already exists

on the computer

The program name is new

(not previously used)

Teach Program

Program step:

Save

Add Step

Remove Step

Move to (X, Y)

Quit

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 375 376

Sem comentários

Dell 3100 Especificações Página 100