Dell Managed PDU LED Manual do Utilizador descarregar pdf (Página 17)

USER’S GUIDE

Managed Rack PDU

Function button • To manually display the current for each phase,

repeatedly press the button. The current displays

for 30 seconds or until you press the button again.

(This functionality is not available for single-phase

Rack PDUs.)

• To display the IP address, press and hold for five

seconds until IP appears; then release. On the

LED display, the address will appear two digits at

a time and then the cycle will repeat.

• To invert the display, press and hold for ten

seconds until the AA pattern appears. Continue

holding the button until AA is oriented as desired

then release the button.

10/100 base-T connector Port for connecting the Rack PDU to the network.

10/100 LED See 10/100 LED.

Network status LED See Network Status LED.

Outlet status LED Illuminates green when the outlet is energized.

(Each outlet has an outlet LED.)

Temp/humidity sensor port Port for connecting a Rack PDU Temperature

Sensor (G853N) or a Rack PDU Temperature/

Humidity Sensor (H621N).

RJ-45 serial port Port for connecting the Rack PDU to a terminal

emulator program for local access to the command

line interface. Use the supplied serial cable.

;

Reset button To restart the interface of the Rack PDU without

affecting the outlets, press and release the Reset

button.

Item Function

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 243 244

Sem comentários

Dell Managed PDU LED Manual do Utilizador Página 17