Dell PowerVault 50F (Fibre Channel Switch) Manual do Utilizador descarregar pdf (Página 21)

Rack Installation Guide 1-5

 !"#$%

+!

To install the slide assembly in the rack, perform the following steps:

1. Align the holes of the stationary and adjustable brackets with the holes in the ver-

tical rail.

The stationary brackets attach to the front of the rack. The adjustable brackets

attach to the back. The top hole of each bracket must align with top hole of an

Electronic Industries Association (EIA) unit in the rack. The top hole of an EIA unit

has a dot next to it (see Figure 1-5).

NOTE: The slides must be installed within 1 EIA unit. The height of the switch

takes up 1 EIA unit.

6-32 x 1/2-inch

screws (4)

mounting clip

back holes

front holes

bezel tab

4939tbk1.book Page 5 Friday, October 8, 1999 1:22 PM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 97 98

Sem comentários

Dell PowerVault 50F (Fibre Channel Switch) Manual do Utilizador Página 21