Dell PowerEdge RAID Controller S110 Manual do Utilizador descarregar pdf (Página 21)

Installing the Drivers 19

Pre-Installation Procedures for the Controller

Drivers

Setting the SATA Controller to RAID Mode

Confirm or change configuration settings at the Dell PowerEdge System

window

Boot the system. When the

Dell Power-On Self-Test (POST)

screen

appears, press <F2>.

When the

Dell PowerEdge System

window appears, scroll to

SATA

Settings

and p

ress <Enter>. At the sub-screen, confirm that the

SATA

Controller

is set to a RAID mode.

NOTE: If necessary, use the space bar to change the setting.

Press <Esc> to exit.

Press <Esc>

again

The following occurs:

– If no change was made at step 2, the boot sequence continues.

– If a change was made at

step 2

, a dialog box appears. Select

Save

Changes and Exit

. Press <Enter>. The boot sequence

continues.

Initializing Physical Disks (as required)

See "Initializing Physical Disks" on page 26.

Creating a Bootable Virtual Disk

See "Creating Virtual Disks" on page 27.

Checking Controller Options and the Boot List Priority

At the

Virtual Disks

field, make sure the bootable virtual disk created

is the first virtual disk listed.

If the bootable virtual disk is not the first virtual disk listed, see "Swapping

two Virtual Disks" on page 31.

NOTE: If Non-RAID virtual disks are used (and appear in the Virtual

Disks list), the Swap Two Virtual Disks option is enabled only if the system

contains a RAID Capable physical disk.

A5_bk0.book Page 19 Thursday, May 29, 2014 11:37 AM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 75 76

Comentários a estes Manuais

Sem comentários

Dell PowerEdge RAID Controller S110 Manual do Utilizador Página 21

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Dell PowerEdge RAID Controller S110