Dell Lifecycle Controller 2 Version 1.3.0 Manual de Serviço descarregar pdf (Página 105)

<n1:Description xsi:nil="true"/>

<n1:ElementName>LC.emb.1</n1:ElementName>

<n1:InstanceID>LifecycleController.Embedded.1#LCAttributes.1#CollectSys

temInventoryOnRestart

</n1:InstanceID>

<n1:IsOrderedList xsi:nil="true"/>

<n1:IsReadOnly>false</n1:IsReadOnly>

<n1:PendingValue xsi:nil="true"/>

<n1:PossibleValues>Enabled</n1:PossibleValues>

<n1:PossibleValues>Disabled</n1:PossibleValues>

<n1:PossibleValuesDescription xsi:nil="true"/>

</n1:DCIM_LCEnumeration>

12.2.5 Get Part Firmware Update Attribute

Get the current Part Replacement firmware update mode as follows:

EXAMPLE:

wsman get http://schemas.dell.com/wbem/wscim/1/cim-

schema/2/root/dcim/DCIM_LCEnumeration

?InstanceID=LifecycleController.Embedded.1#LCAttributes.1#PartFirmwareUpdate

-h $IPADDRESS -V -v -c dummy.cert -P 443

-u $USERNAME -p $PASSWORD -j utf-8 -y basic

NOTE: For 11G, InstanceID=DCIM_LCEnumeration:CCR4

OUTPUT:

<n1:DCIM_LCEnumeration>

<n1:AttributeName>Part Firmware Update</n1:AttributeName>

<n1:Caption xsi:nil="true"/>

<n1:CurrentValue>Allow version upgrade only</n1:CurrentValue>

<n1:DefaultValue>Disable</n1:DefaultValue>

<n1:Description xsi:nil="true"/>

<n1:ElementName>LC.emb.1</n1:ElementName>

<n1:InstanceID>LifecycleController.Embedded.1#LCAttributes.1#PartFirmwa

reUpdate</n1:InstanceID>

<n1:IsOrderedList xsi:nil="true"/>

<n1:IsReadOnly>false</n1:IsReadOnly>

<n1:PendingValue xsi:nil="true"/>

<n1:PossibleValues>Disable</n1:PossibleValues>

<n1:PossibleValues>Allow version upgrade only</n1:PossibleValues>

<n1:PossibleValues>Match firmware of replaced part

</n1:PossibleValues>

<n1:PossibleValuesDescription xsi:nil="true"/>

</n1:DCIM_LCEnumeration>

See Section 12.5 to get the status on whether or not there is a valid

VFlash

license on the system.

12.3 Re-Initiate Auto-Discovery Client

Invoke the ReInitiateDHS() method to reinitialize and restart the Auto-Discovery client. All

configuration information is replaced with the auto discovery factory defaults. Auto discovery can be

disabled, enabled and initiated immediately, or delayed until next power cycle.

Invoke ReInitiateDHS() with the following parameters and syntax:

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 239 240

Comentários a estes Manuais

Sem comentários

Dell Lifecycle Controller 2 Version 1.3.0 Manual de Serviço Página 105

Comentários a estes Manuais

Manuais e produtos relacionados com Software Dell Lifecycle Controller 2 Version 1.3.0