Dell Force10 S4810P Guia do Utilizador descarregar pdf (Página 116)

Usage

Information

If you configure a TELNET client to use a specific VRF, then you need not explicitly

specify the same VRF during the TELNET client sessions corresponding to that VRF.

Example

FTOS(conf)#ip telnet vrf vrf1

FTOS(conf)#do telnet 10.10.10.2

FTOS(conf)#no ip telnet vrf vrf1

ip tftp source-interface

Assign an interface’s IP address in outgoing packets for TFTP traffic.

S4810

Syntax

ip tftp source-interface interface

To return to the default setting, use the no ip tftp source-interface

interface command.

Parameters

interface Enter the following keywords and slot/port or number

information:

• For Loopback interfaces, enter the keyword loopback

then a number from zero (0) to 16383.

• For a Port Channel, enter the keyword port-channel

then a number. For the C-Series and S-Series, the range

is 1 to 128.

• For the SONET interfaces, enter the keyword sonet then

slot/port information.

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

• For VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Defaults The IP address on the system that is closest to the Telnet address is used in the

outgoing packets.

Command

Modes

CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Verison

8.3.19.0

Introduced on the S4820T.

116

Control and Monitoring

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 174 175

Comentários a estes Manuais

Sem comentários

Dell Force10 S4810P Guia do Utilizador Página 116

Comentários a estes Manuais

Manuais e produtos relacionados com Software Dell Force10 S4810P