Dell Force10 S4810P Guia do Utilizador descarregar pdf (Página 108)

ip http source-interface

Specify an interface as the source interface for HTTP connections.

This feature is supported on S4810 platform.

Syntax ip http source-interface interface

To delete an interface, use theno ip http source-interface interface command.

Parameters

interface

Enter the following keywords and slot/port or number

information:

• For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE followed by the slot/port information.

• For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port information.

• For Loopback interfaces, enter the keyword loopback

followed by a number from zero (0) to 16383.

• For a Port Channel interface, enter the keyword port-

channel followed by a number:

– S-Series: 1-128

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port

information.

• For a VLAN interface, enter the keyword vlan followed by

a number from 1 to 4094.

Defaults The IP address on the system that is closest to the Telnet address is used in the

outgoing packets.

Command

Modes

CONFIGURATION

Command

History

Version 9.3(0.1) Introduced on the S4810, S4820T, S6000, and Z9000.

Version 8.3.11.1 Introduced on the Z9000

Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094)

Version 8.1.1.0 Introduced on E-Series ExaScale

Version 7.6.1.0 Support added for S-Series

Version 7.5.1.0 Introduced on C-Series

Commands

ip ftp source interface

Configuring source interface for ftp communications.

108

Control and Monitoring

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 174 175

Sem comentários

Dell Force10 S4810P Guia do Utilizador Página 108