Dell OpenManage Server Administrator Version 5.4 Manual do Utilizador descarregar pdf (Página 189)

Using the Storage Management Service 187

omconfig Connector Commands

The following sections provide the omconfig command syntax required to

execute connector tasks.

omconfig Rescan Connector

Use the following omconfig command to rescan a controller connector. This

command rescans all connectors on the controller and is therefore similar to

performing a controller rescan.

NOTE: This command is not supported on SAS controllers.

Complete Syntax

omconfig storage connector action=rescan

controller=id connector=id

where id is the controller ID and the connector ID as reported by the

omreport command. To obtain these values, enter omreport storage

controller to display the controller IDs and then enter omreport storage

connector controller=ID to display the IDs for the connectors attached to

the controller.

Example Syntax

To rescan connector 2 on controller 1, enter:

omconfig storage connector action=rescan

controller=1 connector=2

Table 6-25. omconfig Connector Commands

Required Command Levels (1, 2, 3) Optional name=value pairs

omconfig storage connector

action=rescan controller=id connector=id

1 2 ... 184 185 186 187 188 189 190 191 192 193 194 ... 257 258

Sem comentários

Dell OpenManage Server Administrator Version 5.4 Manual do Utilizador Página 189