Dell OpenManage Server Administrator Version 5.4 Manual do Utilizador descarregar pdf (Página 175)

Using the Storage Management Service 173

omconfig Blink Physical Disk

You can blink the light (light emitting diode or LED display) on one or more

physical disks attached to a controller. Use the following omconfig command

syntax to blink one or more physical disks.

Complete Syntax

action=blink controller=id pdisk=<PDISKID>

where id is the controller ID. The <PDISK> variable specifies the physical

disk.

To obtain these values, enter omreport storage controller to display the

controller IDs and then enter omreport storage pdisk controller=ID to

display the IDs for the physical disks attached to the controller.

Example Syntax

In this example, you want to blink physical disk 0 on connector 0 of controller 1.

On a SAS controller, the physical disk resides in enclosure 2.

Example for SCSI, SATA, and ATA Controllers

To blink the physical disk described in this example, enter:

omconfig storage pdisk action=blink controller=1

pdisk=0:0

action=offline controller=id pdisk=<PDISKID>

action=online controller=id pdisk=<PDISKID>

action=assignglobalhotspare controller=id pdisk=<PDISKID>

assign=<yes|no>

action=rebuild controller=id pdisk=<PDISKID>

action=cancelrebuild controller=id pdisk=<PDISKID>

action=removedeadsegments controller=id pdisk=<PDISKID>

Table 6-23. omconfig Physical Disk Commands (continued)

Required Command Levels

(1, 2, 3)

Optional name=value pairs

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 257 258

Sem comentários

Dell OpenManage Server Administrator Version 5.4 Manual do Utilizador Página 175