Dell Networking S6000 Guia de Início Rápido descarregar pdf (Página 31)

Installing the Software 27

Default Configuration

A version of Dell Networking OS is pre-loaded onto the S6000 system;

however, the system is not configured when you power up for the first time

(except for the default host name, which is Dell). You must configure the

system using the CLI.

Configuring Layer 2 (Data Link) Mode

To enable Layer 2 data transmissions through an individual interface, use the

switchport command in INTERFACE mode. You cannot configure switching or

Layer 2 protocols such as spanning tree protocol (STP) on an interface unless

the interface has been set to Layer 2 mode.

To configure Layer 2 mode, follow these steps.

To view the interfaces in Layer 2 mode, use the show interfaces switchport

command in EXEC mode.

Configuring a Host Name

The host name appears in the prompt. The default host name is Dell. Host

names must start with a letter, end with a letter or digit, and must have

characters, letters, digits, and hyphens in the string.

To configure a host name, follow this step.

Step Task Command Syntax Command Mode

1 Enable the interface. no shutdown INTERFACE

2 Place the interface in

Layer 2 (switching)

mode.

switchport INTERFACE

Task Command Syntax Command Mode

Create a new host name. hostname name CONFIGURATION

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37

Sem comentários

Dell Networking S6000 Guia de Início Rápido Página 31