Dell Lifecycle Controller 2 Version 1.3.0 Manual do Utilizador descarregar pdf (Página 59)

Lifecycle Controller Integration―Best Practices Specification

1. System should be power off

2. Clear all unfinished jobs

3. Clear all pending data

B) Check NDC is enabled

1. GetBIOSEnumerations(): ENUMERATE the DCIM_BIOSEnumeration class to collect

information about the system. See section 2.2 for a definition of ENUMERATE.

2. Ensure AttributeName of IntegratedNetwork1 is enabled

If it is not enabled, enable it as shown below

 SetBIOSAttributes()

AttributeName=IntegratedNetwork1 AttributeValue=Enabled

AttributeName=BootMode AttributeValue=Bios

 CreateBIOSConfigJob()

 ScheduledStartTime=TIME_NOW RebootJobType=1

 Poll jobstatus for Completed: GET the InstanceID of from 2).

C) CheckConnectFirstFCoETarge(): ENUMERATE the NIC FADD and check if

ConnectFirstFCoETarget is eabled, if not, enable ConnectFirstFCoETarget as show below

 Disable all sources

 Create BIOS job

 SetNICAttributes()

AttributeName=ConnectFirstFCoETarget AttributeValue=Enabled

 CreateNICConfigJob with RebootJobType=1

D) Configure FCoE

1. Disable all sources

2. Create BIOS job

3. Set Partition Attributes as follows:

SetNICAttributes() on NIC.Integrated.1-1-4

AttributeName=FCoEOffloadMode AttributeValue=Enabled

AttributeName=VirtFIPMacAddr AttributeValue=$VirtFIPMacAddr

AttributeName=VirtWWN AttributeValue=$VirtWWN AttributeName=VirtWWPN

AttributeValue=$VirtWWPN AttributeName=MinBandwidth

AttributeValue=$MinBandwidth AttributeName=MaxBandwidth

AttributeValue=$MaxBandwidth

4. CreateNICConfigJob()

5. Set Port Attributes as follows:

SetNICAttributes() on NIC.Integrated.1-1-1

AttributeName=FirstFCoEWWPNTarget AttributeValue=$FirstFCoEWWPNTarget

AttributeName=FirstFCoEBootTargetLUN AttributeValue=$FirstFCoEBootTargetLUN

6. CreateNICConfigJob() with RebootJobType=1

E) GetBootSourceSettings(): ENUMERATE the DCIM_BootSourceSetting class to collect information

about the boot sources. See section 2.2 for a definition of ENUMERATE .

Loop through all boot sources, if boot source is IPL entry, set EnabledState=0 unless HD.

F) ChangeBootSourceState(): Use InstanceID=IPL EnabledState=0 source=(instanceID from D)

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 156 157

Comentários a estes Manuais

Sem comentários

Dell Lifecycle Controller 2 Version 1.3.0 Manual do Utilizador Página 59

Comentários a estes Manuais

Manuais e produtos relacionados com Placas-mãe Dell Lifecycle Controller 2 Version 1.3.0