Dell PowerVault DP500 Manual do Utilizador descarregar pdf (Página 32)

32 iSCSI Connections Using Challenge-Handshake Authentication Protocol

One-Way CHAP Authentication

In One-Way CHAP authentication, only the iSCSI Target authenticates the

Initiator. The secret is set only for the Target and all Initiators that are

accessing the Target must use the same secret to start a logon session with the

Target. To set one-way CHAP authentication, configure the settings

described in the following sections on Target and Initiator.

iSCSI Target Settings

Before you configure the settings described in this section, ensure that few

iSCSI Targets and Virtual Disks are already created and the Virtual Disks are

assigned to the Targets.

On an iSCSI Target, go to

Microsoft iSCSI Software Target Console

→

iSCSI Targets

→

Targ e t na m e

> and either right-click and select

Properties

or go to

Actions

pane

→

More Actions

→

Properties

The

Target Name

> Properties

window is displayed, where

Targ e t Nam e

is the name of the iSCSI Target that you are configuring iSCSI settings

for.

In the

Authentication

tab, select the check box for

Enable CHAP

and

type the User name (IQN name of the Initiator). You can enter the IQN

manually or use the

Browse

option to select the IQN from a list.

Enter the

Secret

, re-enter the same value in

Confirm Secret

, and click

The secret must include 12 to 16 characters.

NOTE: If you are not using IPSec, both Initiator and Target CHAP secrets

should be greater than or equal to 12 bytes and less than or equal to 16 bytes.

If you are using IPsec, the Initiator and Target secrets must be greater than 1

byte and less than or equal to 16 bytes.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Comentários a estes Manuais

Sem comentários

Dell PowerVault DP500 Manual do Utilizador Página 32

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Dell PowerVault DP500