Dell PowerEdge SC1425 Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Hardware de computador Dell PowerEdge SC1425. Dell PowerEdge SC1425 User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 0
Dell™PowerEdge™SC1425SystemsInstallationandTroubleshooting
Guide
Introduction
Indicators, Messages, and Codes
Finding Software Solutions
Running the System Diagnostics
Troubleshooting Your System
Installing System Components
Installing Drives
Getting Help
Jumpers, Switches, and Connectors
I/O Connectors
Service-Only Parts Replacement Procedures
Notes, Notices, and Cautions
Abbreviations and Acronyms
For a complete list of abbreviations and acronyms, see the Glossary in your User's Guide.
Information in this document is subject to change without notice.
©2004DellInc.Allrightsreserved.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell, the DELL logo, Inspiron, Dell Precision, Dimension, OptiPlex, PowerApp, PowerEdge, PowerConnect, PowerVault, DellNet, Axim, Latitude, and Dell
OpenManage are trademarks of Dell Inc.; Intel and Pentium are registered trademarks of Intel Corporation.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any
proprietary interest in trademarks and trade names other than its own.
Initial release: 15 Sept 2004
NOTE: A NOTE indicates important information that helps you make better use of your computer.
NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you how to avoid the problem.
CAUTION: A CAUTION indicates a potential for property damage, personal injury, or death.
Vista de página 0
1 2 3 4 5 6 ... 68 69

Resumo do Conteúdo

Página 1 - Abbreviations and Acronyms

Dell™PowerEdge™SC1425SystemsInstallationandTroubleshootingGuide Introduction Indicators, Messages, and Codes Finding Software Solutions Runnin

Página 2 - System Board Jumpers

Back to Contents Page  Service-Only Parts Replacement Procedures Dell™PowerEdge™SC1425SystemsInstallationandTroubleshootingGuide Recommen

Página 3 - System Board Connectors

 3. Connect the control panel cables. See FigureC-1.  4. Close the system. See "Closing the System" in "Troubleshooting Your Sy

Página 4 - Riser Board Connectors

 Installing the System Board Assembly   1. Unpack the new system board assembly.  2. Align the system board tray so that the tabs on the chas

Página 5

 16. Close the system. See "Closing the System" in "Troubleshooting Your System." Back to Contents Page  NOTE: When installi

Página 6 -  I/O Connectors

Back to Contents Page  Introduction Dell™PowerEdge™SC1425SystemsInstallationandTroubleshootingGuide Other Documents You May Need Your s

Página 7 - Video Connector

Back to Contents Page  Indicators, Messages, and Codes Dell™PowerEdge™SC1425SystemsInstallationandTroubleshootingGuide The system, applica

Página 8 - Integrated NIC Connectors

Table 2-2.DiagnosticIndicatorCodes Hard-drive indicator The green hard-drive activity indicator flashes when the SATA hard drives are in use.

Página 9 - Network Cable Requirements

Back-Panel Features and Indicators Figure2-2 shows the controls, indicators, and connectors located on the system's back panel. Figure 2-2. B

Página 10 - Control Panel Assembly

System Messages System messages appear on the screen during system boot to notify you of a possible problem with the system. Table2-4 lists the sys

Página 11 - System Board

Memory slots DIMM3_A and DIMM3_B must be empty if Dual Rank memory DIMMs are in slots DIMM2_A and DIMM2_B. Remove the memory modules in bank 3. See &

Página 12

Back to Contents Page  Jumpers, Switches, and Connectors Dell™PowerEdge™SC1425SystemsInstallationandTroubleshootingGuide Jumpers—A Genera

Página 13

System Beep Codes If an error that cannot be reported on the screen occurs during POST, the system may emit a series of beeps that identifies the pr

Página 14 -  Introduction

Warning Messages A warning message alerts you to a possible problem and prompts you to respond before the system continues a task. For example, befo

Página 15 - System Status Indicators

Alert Messages Systems management software generates alert messages for your system. Alert messages include information, status, warning, and failur

Página 16

Back to Contents Page  Finding Software Solutions Dell™PowerEdge™SC1425SystemsInstallationandTroubleshootingGuide Before You Begin Tro

Página 17 - NIC Indicators

Back to Contents Page  IRQ2 Interrupt controller 1 to enable IRQ8 through IRQ15 IRQ3 Available IRQ4 Serial port 1 (COM1 and COM3) IRQ5 Available IRQ6

Página 18 - System Messages

Back to Contents Page  Running the System Diagnostics Dell™PowerEdge™SC1425SystemsInstallationandTroubleshootingGuide Using Dell Diagnost

Página 19

1. Create a set of diagnostics diskettes from the Dell OpenManage Server Assistant CD. See "Using the Dell OpenManage Server Assistant" in y

Página 20 - System Beep Codes

Back to Contents Page 

Página 21 - Diagnostics Messages

Back to Contents Page  Troubleshooting Your System Dell™PowerEdge™SC1425SystemsInstallationandTroubleshootingGuide Safety First—For You a

Página 22 - Alert Messages

This section provides troubleshooting procedures for external devices attached to the system, such as the monitor, keyboard, or mouse. Before you perf

Página 23 - Before You Begin

Table A-1.SystemBoardJumperSettings System Board Connectors See FigureA-3 and TableA-2 for the location and description of the system boar

Página 24

 2. Examine the mouse and its cable for signs of damage. If the mouse is not damaged, go to step 4. If the mouse is damaged, continue to the next s

Página 25 - Using Dell Diagnostics

Problem l System message indicates a problem with a USB device. l Device connected to a USB port is not operating properly.  Action  1. Enter th

Página 26

Figure 5-1. Inside the System The system board holds the system's control circuitry and other electronic components. The processor and memory

Página 27 - Back to Contents Page

Figure 5-3. Installing and Removing the System Cover Closing the System  1. Ensure that you did not leave tools or parts inside the system. 

Página 28 - Checking the Equipment

6. Let the system dry thoroughly for at least 24 hours.  7. Reinstall all of the components that you removed earlier in this procedure. See "

Página 29 - Troubleshooting the Mouse

 1. Re-enter the time and date through the System Setup program. See "Using the System Setup Program" in your User's Guide.  2. Tu

Página 30 - Problem

Action   1. Run the appropriate diagnostic test. See "Using Dell Diagnostics" in Running System Diagnostics."  2. Turn off the sy

Página 31 - Inside the System

 10. Enter the System Setup program and check the system memory setting. See "Using the System Setup Program" in your User's Guide.

Página 32 - Opening the System

l Damaged or improperly connected hard-drive cables.  Action   1. Run the appropriate online diagnostic test. See "Using Dell Diagnostics&q

Página 33 - Closing the System

3. Ensure that the primary SCSI channel is enabled, and restart the system. See the documentation supplied with the controller for information about

Página 34

Table A-2.SystemBoardConnectors Riser Board Connectors See FigureA-4 for the location and description of the riser card connectors. Figure

Página 35

Troubleshooting the Processors  Problem l Error message indicates a processor problem. l A heat sink is not installed for each processor.  Act

Página 36

22. Close the system. See "Closing the System."  23. Reconnect the system to the electrical outlet, and turn on the system and attached

Página 37

Back to Contents Page  Installing System Components Dell™PowerEdge™SC1425SystemsInstallationandTroubleshootingGuide This section describes

Página 38

 1. Enter the System Setup program and record the option settings on the System Setup screens. See "Using the System Setup Program" in th

Página 39

 5. Slide the fan modules toward the front of the system to remove them. Figure 6-3. Installing and Removing a Processor/Memory Fan Module  I

Página 40

 Installing the Expansion Card Fan Module  1. With the fan power cable facing towards the rear of the system, align the fan module alignment hole

Página 41

 Installing the Power Supply  1. Lower the power supply in the system and slide the new power supply backward until the power supply is fully seat

Página 42 - System Battery

 3. Remove the filler bracket.  4. Insert the expansion card firmly into the expansion-card connector on the riser card until the card is fully

Página 43

 1. Open the system. See "Opening the System" in "Troubleshooting Your System."  2. If applicable, remove the expansion card.

Página 44

l If only one memory module is installed, it must be installed in socket DIMM1_A. l If two or more memory modules are installed, they must be insta

Página 45 - Power Supply

 1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.  2. Open the system. See "Opening th

Página 46 - Expansion Cards

Installing Memory Modules   1. Open the system. See "Opening the System" in Troubleshooting Your System."  2. Locate the memory m

Página 47 - Riser Card

Processor It is possible to upgrade your processor(s) to take advantage of future options in speed and functionality. Each processor and its associa

Página 48 - System Memory

the processor. Do not pry the heat sink off of the processor.  6. Lift the heat sink off of the processor and set the heat sink upside down so as

Página 49 - Spare Bank Support

 15. Press <F2> to enter the System Setup program, and check that the processor information matches the new system configuration. See your Us

Página 50 - Removing Memory Modules

Back to Contents Page  Installing Drives Dell™PowerEdge™SC1425SystemsInstallationandTroubleshootingGuide Optical Drive SCSI Configurat

Página 51 - Processor

 2. Rotate the drive downward until it snaps into place.  3. Connect the interposer card to the optical drive.  4. Push the plungers into t

Página 52

Remove the CD drive if you are removing hard drive 0. See "Removing the Optical Drive."  3. Disconnect the power and interface cables from

Página 53

Installing a Hard Drive   1. Align the hard-drive mounting holes with the holes in the drive carrier.  2. Using a #2 Phillips screwdriver, insta

Página 54 -  Installing Drives

Back to Contents Page  Getting Help Dell™PowerEdge™SC1425SystemsInstallationandTroubleshootingGuide Technical Assistance Dell Enterpri

Página 55 - Hard Drives

support.jp.dell.com (Japan only) support.euro.dell.com (Europe only) l Electronic Quote Service [email protected] [email protected] (Asian/Pacific c

Página 56

Back to Contents Page  I/O Connectors Dell™PowerEdge™SC1425SystemsInstallationandTroubleshootingGuide Serial Connector PS/2-Compatible

Página 57 - Installing a Hard Drive

the system diagnostics.  4. Include any accessories that belong with the item(s) being returned (such as power cables, media such as CDs and diske

Página 58 -  Getting Help

Country (City) International Access Code Country Code City Code Department Name or Service Area, Website and E-Mail Address Area Codes, Local Numbers,

Página 59 - Product Information

Sales (med./large bus., government) toll-free:1-800-387-5755 Spare Parts Sales & Extended Service Sales 18664403355 Cayman Islands General Sup

Página 60 - Contacting Dell

Fax 0925331399 Switchboard 0925331300 France (Paris) (Montpellier) International Access Code: 00 Country Code: 33 City Codes: (1) (4) Website: s

Página 61

City Code: 1 Corporate Customer Care (dial within U.K. only) 08709074499 Ireland Sales 012044444 U.K. Sales (dial within U.K. only) 08709074000

Página 62

Country Code: 853 Customer Service (Penang, Malaysia) 6046334949 Transaction Sales toll-free:0800581 Malaysia (Penang) International Access Code:

Página 63

Panama General Support 001-800-507-0962 Peru General Support 0800-50-669 Poland (Warsaw) International Access Code: 011 Country Code: 48 City Code: 22

Página 64

Switzerland (Geneva) International Access Code: 00 Country Code: 41 City Code: 22 Website: support.euro.dell.com  E-mail: Tech_support_central_Europ

Página 65

Back to Contents Page  Spare Parts Sales toll-free:1-800-357-3355 Extended Service and Warranty Sales toll-free:1-800-247-4618 Fax toll-free:1-800

Página 66

Back to Contents Page Dell™PowerEdge™SC1425SystemsInstallationandTroubleshootingGuide Notes, Notices, and Cautions Abbreviations and Acron

Página 67

Table B-2.SerialConnectorPinAssignments PS/2-Compatible Keyboard and Mouse Connectors The PS/2-compatible keyboard and mouse cables attach t

Página 68

USB Connectors The system's USB connectors support USB-compliant peripherals such as keyboards, mice, and printers and may also support USB-com

Página 69 - Abbreviations and Acronyms

Network Cable Requirements The NIC supports a UTP Ethernet cable equipped with a standard RJ45-compatible plug. Observe the following cabling restr

Comentários a estes Manuais

Sem comentários