Dell SC PERC 3 Guia do Utilizador descarregar pdf (Página 10)

10 Setting Up Diagnostics

Setup and Diagnostic Requirements

The PowerEdge Diagnostics must be set up on each managed system to run diagnostics locally.

Managed System Requirements

• Your system must have a supported operating system installed. See "Supported Operating Systems."

• You must install Dell-qualified device drivers and firmware to run diagnostics on RAID controllers,

RAID-attached hard drives, tape drives, tape autoloaders, and tape libraries. See the documentation

that accompanied your device for more information, or access the latest drivers and firmware from the

Dell Support website at

support.dell.com

. A list of the latest drivers and firmware versions for

RAID Controllers can be found in the section "Diagnostic Dependencies for Supported

RAID Controllers."

Diagnostic Requirements

• You must be logged in with Administrator privileges to run PowerEdge Diagnostics.

• Table 2-1 lists the devices and the dependencies that are required for each operating system to run the

Diagnostic Service. If these device dependencies are not installed, the Diagnostic Service exhibits the

default behavior described in the table.

Table 2-1. Device Dependencies

Device Operating System Dependency Default Behavior

Intel

NIC Microsoft

Windows

Intel PROSet Utility for Microsoft

Device Manager or Intel PROSet

management agent. You can access the

Intel PROSet Utility for Microsoft

Device Manager from either the Dell

PowerEdge Service and Diagnostic

Utilities CD or from the Dell Support

website at support.dell.com.

Intel vendor network tests are

not available.

Broadcom NIC Red Hat® Enterprise

Linux and SUSE®

Linux Enterprise

Server

Broadcom vendor network tests

are not available.

NOTE: For systems that have a PCIe Intel Network Interface Controller (NIC), Intel PROSet Utility for Microsoft

Device Manager is required for the Intel network adapter diagnostics in Microsoft Windows. If you have a PCI-X Intel

NIC, you may install either the Intel PROSet for Microsoft Device Manager or the Intel PROSet management agent to

enable Intel network adapter diagnostics. If you have any other Dell-supported Intel NIC, you should install the Intel

PROSet management agent. If these requirements are not met, the Intel vendor tests will not be available (only the

default network diagnostics are available).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Comentários a estes Manuais

Sem comentários

Dell SC PERC 3 Guia do Utilizador Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Servidores Dell SC PERC 3