Dell Lifecycle Controller 1.2 for Windows Guia do Utilizador descarregar pdf (Página 205)

Dell™ Lifecycle Controller 2 Web Services Interface Guide for Windows Version: 2.1.0

205

<p:AttributeValue>Enabled</p:AttributeValue>

<p:AttributeName>NIC.1#VLanEnable</p:AttributeName>

<p:AttributeValue>Disabled</p:AttributeValue>

<p:AttributeName>VirtualMedia.1#Attached</p:AttributeName>

<p:AttributeValue>Dettached</p:AttributeValue>

<p:AttributeName>IPv4.1#Enable</p:AttributeName>

<p:AttributeValue>Enabled</p:AttributeValue>

<p:AttributeName>IPv4.1#DHCPEnable</p:AttributeName>

<p:AttributeValue>Enabled</p:AttributeValue>

<p:AttributeName>IPv4.1#DNSFromDHCP</p:AttributeName>

<p:AttributeValue>Enabled</p:AttributeValue>

<p:AttributeName>Users.3#Enable</p:AttributeName>

<p:AttributeValue>Enabled</p:AttributeValue>

…

<p:AttributeValue>Enabled</p:AttributeValue>

<p:AttributeName>Users.16#Enable</p:AttributeName>

<p:AttributeValue>Enabled</p:AttributeValue>

<p:AttributeName>Users.3#IpmiLanPrivilege</p:AttributeName>

<p:AttributeValue>Administrator</p:AttributeValue>

…

<p:AttributeName>Users.16#IpmiLanPrivilege</p:AttributeName>

<p:AttributeValue>Administrator</p:AttributeValue>

<p:AttributeName>Users.3#IpmiSerialPrivilege</p:AttributeName>

<p:AttributeValue>Administrator</p:AttributeValue>

…

<p:AttributeName>Users.16#IpmiSerialPrivilege</p:AttributeName>

<p:AttributeValue>Administrator</p:AttributeValue>

</p:ApplyAttributes_INPUT>

OUTPUT:

ApplyAttributes_OUTPUT

Job

Address = http://schemas.xmlsoap.org/ws/2004/08/addressing/role/anonymous

ReferenceParameters

ResourceURI = http://schemas.dell.com/wbem/wscim/1/cim-schema/2/DCIM_LifecycleJob

SelectorSet

Selector: InstanceID = JID_001293705757, __cimnamespace = root/dcim

ReturnValue = 4096

19.4.2 Polling Job Completion

Use the Get() command to check the progress of the ApplyAttributes() method. It polls for job

completion. This method takes the InstanceID from the previous section (19.3.1) as input. The

JobStatus value is either “Successful” or “Failed”. If the job failed, the Message value contains more

detailed error information on the cause of the failure.

Run the Get() command on DCIM_LifecycleJob with the following parameters and syntax:

EXAMPLE:

1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 225 226

Comentários a estes Manuais

Sem comentários

Dell Lifecycle Controller 1.2 for Windows Guia do Utilizador Página 205

Comentários a estes Manuais

Manuais e produtos relacionados com Servidores Dell Lifecycle Controller 1.2 for Windows