Dell Force10 S55T Manual de Início Rápido

Dell Force10S55 and S60 SystemsQuick Start GuideRegulatory Model: S55/S60

8 Installing the Hardware NOTE: Coat the one-hole lug with an anti-oxidant compound prior to crimping. Bring any un-plated mating surfaces to a shiny

Installing the Hardware 9Install the SFP and SFP+ OpticsThe chassis are shipped as follows:• The S55 has 4 SFP optical ports in the PSU side of the ch

10 Installing the Hardware• The input circuits are correctly sized for the loads and that sufficient over-current protection devices are used.• All pr

Installing the Hardware 11Power SuppliesThe S55 and S60 chassis are designed to support two hot-swappable power supplies with integrated fans that pro

12 Installing the Hardware NOTE: Both slots must have operating fan units to run the system. If a module is not installed in each slot (either as par

Installing the Hardware 13Environmental ParametersAC Power RequirementsDC Power RequirementsPower SuppliesThe S55 and the S60 are designed to support

14 Installing the Hardware WARNING: To prevent electrical shock, make sure the systems are grounded properly. If you do not ground your equipment cor

Installing the Hardware 15Install a DC Power SupplyThe power supply modules should slide into the slots smoothly. Do not force a module into a slot. T

16 Installing the Hardware

Installing the Software 172Installing the SoftwareNavigating CLI ModesThe FTOS prompt changes to indicate the CLI mode. You must move linearly through

18 Installing the SoftwareSerial ConsoleThe RS-232 console port is labeled on the chassis. It is in the upper right-hand side, as you face the rear of

Installing the Software 19USB-B ConsoleThe USB-B connector port is labeled on the S55/S60 chassis. It is to the left of the management ports, as you f

20 Installing the SoftwareDefault ConfigurationA version of the Dell Force10 Operating System (FTOS) is pre-loaded onto the chassis, however the syste

Installing the Software 21Access the System RemotelyYou can configure the system to be accessed remotely by Telnet. Both the S55 and the S60 has a ded

22 Installing the SoftwareConfigure a Username and PasswordConfigure a system username and password to access the system remotely.Configure the Enable

Installing the Software 23Create a Port-based VLANThe Default VLAN as VLAN 1 is part of the system startup configuration and does not require configur

24 Installing the SoftwareUse the untagged command to move untagged interfaces from the Default VLAN to another VLAN:Assign an IP address to a VLAN N

www.dell.com | support.dell.comPrinted in the U.S.A.

Dell Force10S55 and S60 SystemsQuick Start GuideRegulatory Model: S55/S60

Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indic

About this Guide 3About this GuideThis document is intended as a Quick Start Guide to get new systems up and running and ready for configuration. For

4 About this Guide

Installing the Hardware 51Installing the HardwareThis guide assumes all site preparation has been performed before installing the chassis.Installing t

6 Installing the Hardware2 Attach the brackets to the sides of the chassis at the PSU end, using four screws for each bracket. Attach the bracket so t

Installing the Hardware 7Install Chassis into Rack or CabinetEnsure that there is adequate clearance surrounding the rack or within the cabinet to per