Dell 10g Guia do Utilizador descarregar pdf (Página 14)

14 Deployment Guide

Run

install_drivers.bat

NOTE: This procedure may take several minutes to complete.

Press any key to continue.

Check the logs to verify that all drivers were installed correctly.

NOTE: Log information can be found at: C:\Dell_Resource_CD\logs

When installation is complete, remove the CD from the CD drive.

Reboot your system.

Verifying the Temporary Directory Paths

Verify that the paths to the Temp and Tmp directories have been set correctly.

Repeat the following steps for all nodes in the cluster.

Click

Start

and select

Run

In the

Open

field, enter

cmd

and click

At the command prompt, enter

echo %Temp%

. The following path

appears:

%SystemDrive%

\Temp

where

%SystemDrive%

is the user’s local drive.

At the command prompt, enter

echo %Tmp%

. The following path

appears:

%SystemDrive%

\Temp

where

%SystemDrive%

is the user’s local drive.

Repeat all steps in this section for all nodes in the cluster.

Verifying Cluster Hardware and Software

Configurations

Before you begin the cluster setup, ensure that you have the minimum

hardware installed as shown in Table 1-2. This section provides setup

information for hardware and software cluster configurations.

Each node must have the following software installed:

• Windows Server 2003 SP2 Standard x64 Edition (see Table 1-1)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 69 70

Comentários a estes Manuais

Sem comentários

Dell 10g Guia do Utilizador Página 14

Comentários a estes Manuais

Manuais e produtos relacionados com Software de bases de dados Dell 10g