Dell XPS 710 Manual do Utilizador descarregar pdf (Página 39)



Addressing Memory Configurations

If you are using a 32-bit operating system such as Microsoft

Windows

XP, your computer will support a maximum of 4 GB of memory. If you are using a 64-

bit operating system, your computer will support a maximum of 8 GB (2-GB DIMMs in each of the four slots) of memory.



Installing Memory



1. Follow the procedures in Before You Begin.



2. Remove the computer cover (see Removing the Computer Cover).



3. Press out the securing clip at each end of the memory module connector.



4. Align the notch on the bottom of the module with the crossbar in the connector.

matched pair of modules in DIMM connectors 1 and 2 (white securing

clips)

matched pair of memory modules in DIMM connectors 3 and 4 (black securing

clips)

NOTICE: If you remove your original memory modules from the computer during a memory upgrade, keep them separate from any new modules that

you may have, even if you purchased the new modules from Dell. If possible, do not pair an original memory module with a new memory module.

Otherwise, your computer may not start properly. You should install your original memory modules in pairs either in DIMM connectors 1 and 2 or DIMM

connectors 3 and 4.

NOTE: Memory purchased from Dell is covered under your computer warranty.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge and damage to internal components, ground yourself by using a wrist grounding strap or by periodically

touching an unpainted metal surface on the computer chassis.

memory connector closest to processor

securing clips (2)

memory connector

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 104 105

Sem comentários

Dell XPS 710 Manual do Utilizador Página 39