Dell Dimension L___cx Manual do Utilizador descarregar pdf (Página 50)

3-8 Dell Dimension L Series Systems Reference and Troubleshooting Guide

Figure 3-6. Locating Rails for the Upper 3.5-Inch Drive Bay

7. Slide the drive assembly into the drive bay.

8. If you are installing a controller card, configure and install it in an expansion slot pansion slot

now (refer to “PCI Expansion Card Upgrades” in Chapter 2 for instructions).

Install the card as close as possible to the drive cage.

NOTICE: Dell does not recommend routing cables over cards because the

cables can restrict airflow, cause cooling problems, and interfere with

removing and replacing the computer cover. If you must route cables over

cards, be extremely cautious when removing and replacing the computer

cover.

9. Connect a DC power cable to the drive as described earlier in “Connecting Drive

Cables.”

NOTICE: Match the colored strip on the cable with pin 1 on the interface

connector.

10.0. Attach the appropriate interface cable to the drive. If you installed a controller

card in step 8, attach the other end of the interface cable to the controller card

rather than the system board.

11. Replace the bezel.

front of chassis

left rail

right rail

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 161 162

Sem comentários

Dell Dimension L___cx Manual do Utilizador Página 50