Dell PowerVault DP500 Manual do Utilizador descarregar pdf (Página 14)

14 Getting Started

Network Configuration

Cabling and Configuring Your Network Connection

Connect one end of an Ethernet cable into one of the RJ-45 network

interface connectors (NIC) (see Figure 1-8) on the back of your system.

See the

Hardware Owner’s Manual

for the NIC locations.

Connect the other end of the Ethernet cable to a functioning Ethernet

jack.

Verify that the NIC connector LED is lit (see Figure 1-8). If the LED is

steady green, the connection is good. If the LED is flashing amber, data is

successfully being transferred.

If the LED is not lit, make sure that each end of the Ethernet cable is

seated properly in the NIC connector and Ethernet jack.

Figure 1-8. NIC Connector

NOTE: The NIC connector’s physical orientation may vary depending on your

system. See your system’s Hardware Owner’s Manual for more information.

Configuring TCP/IP Using DHCP (Default Setting)

Dynamic Host Configuration Protocol (DHCP) is enabled by default on your

system. If your network is not configured with a DHCP server, proceed to

"Configuring TCP/IP Using a Static IP Address" on page 15 to configure a

static IP address on your system. Use the following procedure to verify your

system’s DHCP configuration.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Sem comentários

Dell PowerVault DP500 Manual do Utilizador Página 14