Dell KVM 1081AD/ KVM 2161AD Manual do Utilizador descarregar pdf (Página 29)

Installationxxx | xxx21

3 (Optional) Assemble the blanking panel to the rails on the front side of the

rack and tighten the thumbscrews (item 3).

To remove the switch from the rack:

1 Unscrew the thumbscrews and pull the switch assembly out of the rack until

the travel stops are reached. The travel stop position is intended to provide

the opportunity to reposition the rail grip; it is not intended for service.

2 Locate the blue tabs on the sides of the switch rails (item 4).

3 Push the tabs inward and continue pulling the assembly until the switch

rails are clear of the ReadyRails assemblies.

1U Front-rack Installation

Before installation, the rails that are attached to the switch must be re-

configured.

1 On each switch rail, lift the tab under the front standoff and slide the rail

forward as you lift the rail from the switch (Figure 2.6, item 1).

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 139 140

Sem comentários

Dell KVM 1081AD/ KVM 2161AD Manual do Utilizador Página 29