Dell Networking S6000 Guia do Utilizador descarregar pdf (Página 102)

FTOS(conf)#ip telnet server vrf management

FTOS(conf)#no ip telnet server vrf

ip telnet source-interface

Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.

S6000

Syntax

ip telnet source-interface interface

To return to the default setting, use the no ip telnet source-interface

[

interface] command.

Parameters

interface Enter the following keywords and slot/port or number

information:

• For Loopback interfaces, enter the keyword loopback

then a number from zero (0) to 16383.

• For a Port Channel, enter the keyword port-channel

then a number. The range is from 1 to 128.

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

• For VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

• For a tunnel interface, enter the keyword tunnel.

Defaults The IP address on the system that is closest to the Telnet address is used in the

outgoing packets.

Command

Modes

CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0 Introduced on the S6000.

Version

8.3.19.0

Introduced on the S4820T.

Version 8.3.11.1 Introduced on the Z9000.

Version 8.3.7.0 Introduced on the S4810.

102

Control and Monitoring

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 150 151

Sem comentários

Dell Networking S6000 Guia do Utilizador Página 102