Dell PS4100 Guia de Instalação descarregar pdf (Página 20)

PS4100 Installation Guide Connecting the Array Cables

Figure 5 Connecting the Power Cables

Connect the Array to the Network

The PS4100 array model includes two Type 12 control modules. The Type 12 control module contains 2

1GB Ethernet ports, labeled Ethernet 0 and Ethernet 1.

The control modules also include one 10Mb/100Mb port labeled Management. The management port

cannot carry iSCSI traffic. Use the management port only if you configure a management network. See the

Group Administration manual for more information.

Obtain the appropriate number of Ethernet network cables.

One functioning network connection is required for array operation. Multiple network connections are

recommended for performance and high availability. See Minimum and Recommended Cable

Configurations on page 10 for additional information.

Turning On the Array

Before turning on power, allow sufficient time for the array to adjust to ambient temperature (for example,

overnight).

Note: You can turn on the power to one power supply first (either one), or both at the same time.

1. Find the power switch, located below the power plug on each power supply and cooling module.

2. Press the power switch to the ON position. The power indicators will light.

Batteries will start to charge and some hardware components will start to synchronize. LEDs will indicate

these normal activities.

See Figure 6 and Table 4.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 48 49

Sem comentários

Dell PS4100 Guia de Instalação Página 20