
Installation Guide 9
Install DHCP Server
If you are using RIS, you must install and configure a DHCP server. The DHCP server is required for
network installation of compute nodes. To install and configure the DHCP server:
1
Click
Start
→
Programs
→
Administrative Tools
→
Manage Your Server
.
2
In the
Manage Your Server Roles
window, click
Add or remove a role
and click
Next
.
3
Select
DHCP server
and click
Next
.
4
In the
Summary
window, click
Next
.
The installer runs and you may be prompted to insert the operating system CD.
5
In the
New Scope
wizard, click
Next
. Complete the following steps to set the scope parameters and to
activate the scope:
a
In the
Scope Name
screen, select a name and description for the scope and click
Next
.
b
In the
IP Address Range
screen, enter a scope on the same subnet as your primary network
interface (NIC 1) that is large enough to cover all of the compute nodes and click
Next
.
c
In the
Add Exclusions
screen, enter any exclusion ranges or IP addresses as requied and click
Next
.
d
In the
Lease Duration
screen, enter a lease duration and click
Next
.
e
In the
Configure DHCP Options
screen, select
Configure additional DHCP options
and
click
Next
.
f
In the
Router (Default Gateway)
screen, configure a router if required and click
Next
.
g
In the
Domain Name and DNS Servers
screen, configure a domain name and DNS server and
click
Next
.
h
In the
WINS Server
screen, configure a WINS server if required and click
Next
.
i
In the
Activate Scope
screen, select
To activate the scope now
and click
Next
.
j
Click
Finish
to exit the wizard.
6
Click
Finish
again.
Authorize the DHCP Server
1
Click
Start
→
Programs
→
Administrative Tools
→
Manage Your Server
.
2
In the
DHCP Server
entry, click
Manage this DHCP server
.
3
In the
DHCP Control
window, right-click the server name and select
Authorize
.
4
Close the
DHCP Server
window.
Comentários a estes Manuais