Dell OPENVIEW NNM SE 1.2 Guia de Resolução de Problemas descarregar pdf (Página 113)

support.dell.com Repair and Replacement 6-5

Figure 6-5. Removing the Fan Assembly

Removing the Fan Assembly

1. Disconnect the fan assembly’s wiring harness from the center of the system

board, as shown in Figure 6-5. Do not pull the connector wires.

2. Clear the metal tabs in front of the assembly by gently pushing the top of the tab

toward the outside of the unit and the bottom to the inside.

3. After releasing the tabs, gently rotate the bottom of the assembly towards the

front of the switch.

4. Pull the assembly up and back until you can slide it forward off the metal slats

attached to the back of the chassis.

Installing a New Fan Assembly

1. Tilt the assembly slightly up and slide it onto the two metal slats protruding from

the back of the chassis.

2. Move aside the power supply wiring harnesses, lower the assembly onto the

metal tabs protruding from the back of the power supply chassis.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 155 156

Sem comentários

Dell OPENVIEW NNM SE 1.2 Guia de Resolução de Problemas Página 113