Dell SP2008WFP Monitor Manual do Utilizador descarregar pdf (Página 16)

Using the OSD Menu

1. Press the Menu button to open the OSD menu and display the main menu.

or

OSD menu / select

The Menu button is used to open and exit the on-screen display (OSD), and exit from menus and sub-menus. See

Using the OSD Menu.

Down (-) and Up (+)

Use these buttons to adjust (decrease/increase ranges) items in the OSD menu.

Brightness Menu

Use this button to launch Brightness menu.

Auto Adjust

Use this button to activate automatic setup and adjustment. The following dialog appears on a black screen as the

monitor self-adjusts to the current input:

Auto Adjustment button allows the monitor to self-adjust to the incoming video signal. After using Auto

Adjustment, you can further tune your monitor by using the Pixel Clock (Coarse), Phase (Fine) controls in the OSD.



Auto Adjust In Progress

NOTE: Auto Adjust does not occur if you press the button while there are no active video input signals or

attached cables.

Power Button and Indicator

Usethepowerbuttontoturnthemonitoronandoff.

Thebluelightindicatesthemonitorisonandfullyfunctional.Anamberlightindicatespowersavemode.



NOTE: Ifyouchangethesettingsandtheneitherproceedtoanothermenu,orexittheOSDmenu,themonitorautomaticallysavesthose

changes.ThechangesarealsosavedifyouchangethesettingsandthenwaitfortheOSDmenutodisappear.

Main Menu for Auto Detect Analog (VGA) Input



Main Menu for Auto Detect Digital (DVI) Input

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 30 31

Sem comentários

Dell SP2008WFP Monitor Manual do Utilizador Página 16