Dell PowerVault NX3000 Manual do Utilizador descarregar pdf (Página 111)

Installing System Components 111

If not already done, route the interface and RAID battery cables in the

cable path inside the right interior wall of the chassis beneath the cable

retention bracket. See "Cable Routing" and Figure 3-21 through

Figure 3-23.

Connect the SAS A cable to the SAS A connector on the backplane and, if

applicable, connect the SAS B cable to the SAS B connector on the

backplane.

Close the system. See "Closing the System."

Reconnect your system and peripherals to their electrical outlets, and turn

on the system.

Figure 3-21. Storage Controller Card Cabling (3.5-inch Hard-Drive Chassis)

1 RAID battery (PERC only) 2 SAS B connector on backplane

3 SAS A connector on backplane 4 cable retention bracket

5 integrated storage controller card 6 SAS_0 connector

7 SAS_1 connector 8 RAID battery connector (PERC only)

1 2 ... 106 107 108 109 110 111 112 113 114 115 116

Sem comentários

Dell PowerVault NX3000 Manual do Utilizador Página 111