Dell PowerVault NX1950 Manual do Utilizador

Dell PowerVault NX1950 configuration guide for VMware® ESX Server software January 2008 Dell | Global Solutions Engineerin

7. ConfigureiSCSIstorageonESXServerConnect to the ESX Server/VirtualCenter using VI Client and follow the steps below. 1. Go to the configura

THIS DOCUMENT IS FOR INFORMATIONAL PURPOSES ONLY, AND MAY CONTAIN TYPOGRAPHICAL ERRORS AND TECHNICAL INACCU

Table of Contents 1. Introduction... 3 2. Archite

1. Introduction Dell™ PowerVault™ NX1950 is a unified network storage solution that simultaneously stores both file and application data while suppo

2. ArchitecturalSetupThe following figure illustrates a typical setup for using NX1950 in an ESX Server farm. As a best practice, Dell recommends u

4. PowerV aultNX1950storagesetupandconfigurationFor information on storage configuration on NX1950, refer to NX1950 Deployment Guide at http://

5. iSCSISoftwareInitiatorConfigurationonESXServerThis section lists the steps required to configure the software initiator on the VMware ESX

Figure 5: iSCSI software initiator after initial configuration 5. Select Properties under storage adapters. Select Dynamic Discovery. Selec

6. iSCSITargetandVirtualDiskConfigurationonNX19506.1 CreateiSCSITargetFollow the below steps to create an iSCSI target on the NX1950. Ope

6.2 CreateVirtualDisks 1. Right click newly created iSCSI target and select Create Virtual Disk for iSCSI Target. The create virtual disk wizard