Dell PowerVault MD3000i Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Hardware de computador Dell PowerVault MD3000i. Dell PowerVault MD3000i User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 4
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
WARNING: A WARNING indicates a potential for property damage, personal injury,
or death.
Replacing a RAID Controller Module
in a Single-Controller MD3000i
This document describes how to replace a failed RAID controller module in a
single-controller MD3000i. After replacing the RAID controller, you will also
need to update its controller and NVSRAM firmware. These steps are described
in "Updating RAID Controller and NVSRAM Firmware on the Replacement
RAID Controller Module" later in this document.
Replacing the RAID Controller Module
WARNING: Always wear a wrist grounding strap when handling equipment with
static-sensitive components. See your
Product Information Guide
for safety
information.
Removing the RAID Controller Module
1
Power down the MD3000i enclosure.
2
Disconnect all cables from the failed RAID controller module.
3
Push up on the release tab on the left side of the module (see Figure 1).
4
At the same time, pull out on the release lever. When the lever is pulled out,
the controller module partially ejects from the enclosure.
5
Remove the module from the enclosure and place it on a flat, secure surface.
CAUTION: To avoid damage to the sensitive EMI (ElectroMagnetic Interference)
contacts on the bottom of the controller module, do not stack or place the module on a
hard surface.
Vista de página 0
1 2 3 4

Resumo do Conteúdo

Página 1 - Product Information Guide

WARNING: A WARNING indicates a potential for property damage, personal injury, or death.Replacing a RAID Controller Module in a Single-Controller MD

Página 2 - 1 release tab 2 release lever

Figure 1. Removing and Installing a RAID Controller ModuleInstalling a Replacement RAID Controller Module1Carefully insert the replacement RAID contro

Página 3

Updating RAID Controller and NVSRAM Firmware on the Replacement RAID Controller ModuleThe following procedure is required only if a single controller

Página 4 - ____________________

____________________Information in this document is subject to change without notice.© 2008 Dell Inc. All rights reserved.Reproduction in any manner w

Comentários a estes Manuais

Sem comentários