Dell PowerVault MD3000 Manual do Utilizador descarregar pdf (Página 8)

Dell MD Storage Array vCenter Plug-in | 8

Configuring the Application Server and

the vCenter Plug-In

After the application server and the vCenter Plug-in were installed, verify that the vCenter Plug-in was

successfully registered with the vCenter server.



Open the vSphere Client to the vCenter Server.



On the menu bar, select

Plug-ins->Manage Plug-ins.



The Dell MD Storage Array vCenter Management Plug-in is listed as Enabled.



However if the vCenter Plug-in is listed as disabled with an error message stating that it cannot

communicate with the application server, verify that the port number defined for the Jetty server is

enabled to pass through any firewalls that might be in use. The default Jetty TCP port number is 8084

and 8081.

After the application server and vCenter server have been configured, the

Dell MD Storage Array vCenter

Management vCenter Plug-in icon

appears in the Solution and Application section of the vSphere Client

page.

Figure 2 vSphere Client Home Page

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 51 52

Sem comentários

Dell PowerVault MD3000 Manual do Utilizador Página 8