Dell PowerVault MD3000 Manual do Utilizador Página 9

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 92
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 8
Updating to Support SATA II Disks 9
2
While the enclosure is still attached to the PERC SAS controller, upgrade
the MD1000 firmware to version A03 or above. Windows systems users
can reference the DUP.exe package; for Linux systems, users can reference
the DUP.bin package available on
support.dell.com
.
NOTE: MD1000 EMM firmware versions A00 and A01 are not supported in an
MD1000 expansion enclosure attached to a MD3000 storage array enclosure.
3
Before adding the MD1000 enclosure(s), make sure the MD3000 software
is installed and up to date. For more information, refer to the
MD3000
Support Matrix
available on
support.dell.com
.
a
Install or update (to the latest version available on
support.dell.com
)
the MD Storage Manager on each host server. Install or update (to the
latest version available on
support.dell.com
) the multipath drivers on
each host server. The multipath drivers are bundled with Modular
Disk Storage Management install. On Windows systems, the drivers
are automatically installed when a Full or Host selection is made.
b
Using the MD Storage Manager, update the MD3000 RAID controller
firmware to the latest version available on
support.dell.com
(
Support
Download Firmware
Download RAID Controller Module
Firmware
) and the NVSRAM (
Support
Download Firmware
Download RAID Controller Module NVSRAM
).
4
Stop I/O and turn off all systems:
a
Stop all I/O activity to the array and turn off affected host systems
attached to the MD3000.
b
Turn off the MD3000.
c
Turn off the MD1000 enclosure(s).
5
Referencing the applicable configuration for your rack (Figure 2-1 through
Figure 2-5 of the installation guide), cable the MD1000 enclosure(s) to the
MD3000.
6
Turn on attached units:
a
Turn on the MD1000 expansion enclosure(s). Wait for the enclosure
status LED to light blue.
b
Turn on the MD3000 and wait for the status LED to indicate that the
unit is ready if:
book.book Page 9 Monday, November 19, 2007 4:22 PM
Vista de página 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 91 92

Comentários a estes Manuais

Sem comentários