Dell PowerVault DP600 Manual do Utilizador descarregar pdf (Página 15)

Operating System Reinstallation 15

Operating System Reinstallation

This section describes the process of reinstalling the operating system on your

PowerVault system.

NOTE: Your operating system was pre-installed when you purchased your system.

Only perform the steps in this section if required to repair a non-functioning

operating system.

Using the Dell Systems Build and Update Utility

Use the Dell Systems Build and Update Utility CD that came with your

solution to reinstall the operating system. The Systems Build and Update

Utility installs the operating system software, device drivers, and

OpenManage™ Server Administrator (OMSA) software.

Your system is factory-installed with Microsoft

Windows

Storage

Server

2003 R2 X64 with SP2. The Dell Systems Build and Update Utility

will need the original Microsoft installation media in order to install the

operating system.

NOTE: Using the Dell Systems Build and Update Utility erases all data from the

virtual disk where you are installing the operating system.

To reinstall the operating system, perform the following steps:

Connect a keyboard, mouse, and monitor to your system.

Power on your system.

Insert the

Dell Systems Build and Update Utility

CD into the system’s

optical drive and configure the BIOS setting to boot off that drive.

Reboot the system.

After the system boots from the CD, the

System Build and Update Utility

screen appears (see Figure 4-1).

Select the appropriate language and keyboard type on the left side of the

screen and select the

Server OS Installation

option under the

Single

Server Solution

section.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Sem comentários

Dell PowerVault DP600 Manual do Utilizador Página 15