Dell PowerEdge SC1420 Manual do Utilizador

Dell™PowerEdge™SC1420SystemsServiceOnlyPartsReplacementProcedures Before You Begin Recommended Tools Bezel Control Panel I/O Panel Chass

 13. While pulling up on the two system board tray release tabs, slide the tray toward the front of the system and then remove the system board tra

 16. Reconnect the system to the electrical outlet, and turn on the system. Back to Contents Page 

Back to Contents Page Dell™PowerEdge™SC1420SystemsServiceOnlyPartsReplacementProcedures For a complete list of abbreviations and acronyms,

Back to Contents Page Dell™PowerEdge™SC1420SystemsServiceOnlyPartsReplacementProcedures Before You Begin Recommended Tools Bezel 

 Installing the Bezel  1. Align the seven bezel release tabs with the system.  2. Press the bezel onto the system until it snaps into place.

 6. Carefully pull the control panel cable through the front panel while removing the control panel.  Installing the Control Panel  1. Carefull

 5. Slide the I/O panel backward and remove the I/O panel from the system.  Installing the I/O Panel  1. Align the I/O panel with the two secur

 5. Remove the switch and its attached cable from the system.  Installing the Chassis Intrusion Switch  1. Align the chassis intrusion switch w

 4. Insert the tabs and lower the memory cooling fan and shroud until it snaps into place.  5. Connect the memory cooling fan and shroud power

 5. While pressing the power-supply release button, slide the power supply toward the back of the system. See Figure1-7. Figure 1-7. Removing a

System Board   The system board and system board tray are removed and replaced as a single assembly.  Removing the System Board  1. Turn off the